Hydroprufe DPM
Application

For use as a proprietary floor membrane that will resist ground moisture and rising damp. The membrane is suitable for use in most domestic, commercial and industrial buildings that are not subject to hydrostatic pressure. The 300 and 500 micron membranes meet the requirements for use as a gas control membrane against radon or on gas contaminated land in accordance with the recommendations published by the Building Research Establishment (BRE) and the Building Regulations (E&W).

Description

High performance damp proof membrane which is manufactured from a blown film of extruded low-density polyethylene, suitable for use in concrete floors and structures where hydrostatic pressure is not encountered. Hydroprufe DPM is available in a range of nominal thicknesses to suit a wide range of applications.

Features/ Benefits:

  • Comprehensive range to suit most domestic and low rise buildings.
  • Manufactured from over 90% recycled materials.
  • Low cost.
  • Ease of application.
  • Good resistance to puncture.
  • Radon resistance.

Applications:

For use as a proprietary floor membrane that will resist ground moisture and rising damp. The membrane is suitable for use in most domestic, commercial and industrial buildings that are not subject to hydrostatic pressure. The 300 and 500 micron membranes meet the requirements for use as a gas control membrane against radon or on gas contaminated land in accordance with the recommendations published by the Building Research Establishment (BRE) and the Building Regulations (E&W).

Ancillary components:

Can be used with the following to create a complete membrane solution:

  • HCR Butyl Tape.
  • HCR Girth Tape.
  • Premcrete protection board 600.

General information

Uniclass 2015

Pr_25_57_65_60 Plastics sheetsPrimary

CAWS

J40/120 Loose laid plastics or rubber sheet damp proofing

J40/130 Loose laid plastics or rubber sheet oversite damp proofing

J40/20 Loose laid plastics or rubber sheet damp proofing

J40/30 Loose laid plastics or rubber sheet oversite damp proofing

Specification data - Plastics sheets Enhanced data

Product Reference

Hydroprufe DPM

Thickness

0.25 mm

0.3 mm

0.5 mm

Standard product features

Roll size:

4 x 12.5 or 25 m.

Technical properties:

  • Tensile strength: 24 MPa.
  • Elongation at break: 715%.
  • Tear strength: 85 N.

Similar products from FIS Products