The RIM800 Addressable Relay Interface Module provides

one volt-free changeover contact unsupervised output.

The relay is controlled by a command sent from the Tyco

MX Control and Indicating Equipment (CIE) via the MX

addressable loop and may be used to signal states to other

systems (e.g. security systems) or to energise loads such

as Door Holders. The relay operation is determined by the

c.i.e. programming. The RIM800 has a red LED which may

be configured to indicate relay activation and c.i.e. polling.

Features and benefits:

Addressable changeover volt-free relay contact
LED indication of relay operation
Common MX module footprint
Range of mounting enclosures
ActivFire Listed afp-1446
FPANZ Listed VF/642.

The RIM800 is supplied as an open circuit board (PCB)

with mounting hardware and must be fitted in a suitable

enclosure. It may be mounted on a gear plate using plastic

standoffs, to an M520 Ancillary Cover and K2142 back box,

or fitted into a D800 Ancillary Housing. The K2142 mounting box provides a convenient surface mounting enclosure and the M520 Cover is designed to accommodate the RIM800.

The RIM800 is shipped with a default (invalid) address of

255 and must be set to the correct loop address using the

850EMT or MX Service Tool and programming lead.

RIM800 CPR