A one part, wet-on-wet liquid applied roof waterproofing system. Due to its excellent adhesion it can be applied on several surfaces: plywood, bitumen membranes, asphalt, metals, brick and concrete.

Components:

ShieldSEAL is a waterproofing system that consists of the following:

ShieldSEAL PU Primer - Two-component, polyurethane-based primer for use over concrete substrates (where required).
ShieldSEAL - Single component waterproofing based on polyurethane resin.
ShieldSEAL Top - Two-component polyurethane resin UV-protection finishing layer.
ShieldSEAL Grip - Plastic beads mixed in to SHIELDSeal Top to provide a rough surface for walkways.

Technical characteristics:

Density: ShieldSEAL - 1.3–1.4 kg/m³; ShieldSEAL Top: 1.3 kg/m³.
Viscosity at 23°C: 2.0–8.0.
Dry extract: >90.
Flash point: 42°C.
Ashes at 450°C weight: 42–47%.
Temperature: 2°C and rising and not exceeding 30°C.
Hardness Shore A at 23°C: C >75.
Tensile strength: Reinforced with ShieldSEAL matting >10 MPa.
Dry time: 2–8 hours. Fully cured in 24 hours.
Tensile strength: 7 MPa.
Overcoat time: +5 ~ +48 hours.
Elongation: >400%.
Water vapour resistance: u = 2.500.
Concrete adherence: >2 MPa.
Percentage solids: ShieldSEAL - 90%; ShieldSEAL TOP - 60%.

Features and benefits:

Cold applied, no heat required.
Suitable for flat (zero falls) roofs.
BBA Approved - cert no. 19/5645.
Durable - lasts for 25 years when installed as per manufacturers guidelines.
When applied to a concrete substrate, it can accept limited foot traffic and light concentrated loads without damage.
Weather tightness - System will resist passage of moisture into buildings.
Self terminating.

19/5645 ShieldSEAL Cold Applied Waterproofing System