WRAS approved, flow-optimised press connector system made of copper (99.9 % Cu-DHP), gunmetal or silicon bronze for copper pipes up to 108mm. Press connectors for protecting the sealing element equipped with cylindrical pipe guide. Press connectors from d64.0 with stainless steel cutting ring to ensure the mechanical strength of the connection.

Suitable for concealed and pre-wall installations of riser pipes and floor installation.

Sealing element:

Black EPDM (ethylene propylene diene rubber), heat-resistant up to 110°C, and not resistant against hydrocarbon solvent, chlorinated hydrocarbon solvents, turpentine or petrol. It is highly resistant to ageing, ozone, sunlight, weathering and environmental influences. The high quality EPDM sealing element is protected against damage by the internal cylindrical pipe guide.

Press connectors:

The press connectors have a circumferential bead in which the sealing element lies. The connector is deformed in front of and behind the bead, and permanently connected to the pipe during pressing. The sealing element is not deformed during pressing. Viega's distinctive hexagonal pressing pattern bonds fitting and pipe and provides the mechanical strength for the connection.

The connectors may only be pressed with Viega press machines with constant pressing force (e.g. Pressgun 6 Plus).

With SC‑Contur, any connections which remain un-pressed become visible when the system is filled. The SC‑Contur is certified and fulfils the requirements of DVGW worksheet W 534, point 12.14, connectors with forced leakage.

Viega guarantees that unpressed connections are visible during a leakage test:

With the wet leakage test in the pressure range from 0.1–0.65 MPa (1.0–6.5 bar).
With dry leakage test in the pressure range from 22 hPa–0.3 MPa (22 mbar–3.0 bar).

Operating conditions

The press connector system Profipress can be used with the following operating parameters:

Potable water installation according to DIN 1988‑200 / DIN EN 806‑2

Operating temperature max. 80 °C / 176 °F

Temperature max. 95°C over a period of 60 min.

Heating systems in accordance with DIN EN 12828 Operating temperature max. 105 °C / 221 °F

The press connector system Profipress is designed for nominal pressure PN 16

Press connector material Copper: 99.9 % Cu-DHP Gunmetal: CC499K Silicon bronze: CC246E / CuSi4Zn9MnP

Viega Profipress fittings are offered in various configurations, including:

Elbows and T-pieces.
Adapter pieces/ adapter elbows.
Couplings and reductions.
Flanges.
Wall plates.
Wall lead-ins.
Smartloop inliner technology; internal circulation pipes.
Compensators.
Gunmetal shut-off valves and ball valves.
Free-flow valves.
Concealed free-flow valves, concealed straight seat valves.
Manifolds, cross pieces.
Radiator connections.
Skirting board radiator connection pieces.
Accessories.

Corrosion resistance:

Depending on the area of use, corrosion protection measures may be necessary. The manufacturer suggests over-ground pipelines and fittings in rooms which do not normally require external corrosion protection.

They suggest exceptions in the following cases:

Contact with aggressive building materials such as nitrite, or materials containing ammonium.
In aggressive surroundings.

If external corrosion protection is required, the manufacturer recommends that the following regulations are followed:

DIN EN 806-2.
DIN 1988-200.
DKI information publication i.160.

WRAS Approval - 'PROFIPRESS & SANPRESS' RANGES OF PRESS-FIT FITTINGS FOR USE WITH COPPER TUBE