Fibre-reinforced, high temperature grade vinyl adhesive.
STYCCOBOND F48PLUS is a fibre-reinforced, solvent free adhesive having high resistance to both heat and PVC plasticisers making it suitable for use in conservatories and areas where floor to ceiling windows are installed. It is protected against biodegradation and is suitable for use over normal underfloor heating installations.
STYCCOBOND F48PLUS can be used for securing a wide range of plasticised PVC and rubber floorcoverings in both sheet and tile form.
See the F. Ball Recommended Adhesives Guide for details of specific floorcoverings.
STYCCOBOND F48PLUS can be applied to structurally sound, smooth, dry subfloors of concrete and sand/cement screed, STOPGAP smoothing underlayments, plywood and hardboard.
STOPGAP waterproof surface membranes, sound flooring grade asphalt and other non-absorbent surfaces must be skimmed with a minimum of 3mm of the appropriate STOPGAP smoothing underlayment.
For details on other subfloors, contact our Technical Service Department
Highly absorbent subfloors such as sand/cement screeds and plywood etc. may cause rapid drying of the adhesive, thus reducing the open time. Use STOPGAP P131 diluted4 parts of water and stir until thoroughly dispersed. This should be allowed to dry thoroughly before proceeding with the installation.
Dry and suitably prepared calcium sulphate screeds e.g. anhydrite must be primed with neat STOPGAP P121 - refer to the STOPGAP P121 data sheet for further information. ADHESIVE APPLICATION
Holding the trowel at an angle of 60°, spread the adhesive evenly over an area of subf
M50/10 Resilient floor tiling
M50/110 Resilient floor tiling
Styccobond F48 Plus