Secured By Design
Electrically operated sliding rooflight with roof tracks to support opening section allowing larger sizes to be manufactured providing 100% opening. Includes dual colour thermally broken framework.
Sliding rooflight with one section sliding on rails over a roof, creating a 100% clear opening. All the glass is flush to allow water runoff and easy cleaning. Thermally broken frame detail and insulated flashings on the sliding frame almost eliminates direct contact between the warm internal frame and the exterior cold air, reducing heat loss and condensation. Carriage design includes large diameter wheels to give minimal rolling resistance on the anodized rails.
All Glazing Vision sliding rooflights are low-noise in operation and have built in electronic solid-state controls with battery back-up, manual override, speed control and creep-speed sealing at end of travel as standard. Units are factory pre-assembled and tested, usually craned into position, fitted and commissioned within day. Manual override of the unit is via a 90° turn of an Allen key to engage/ disengage the motor from the drive mechanism and allow the product to be pushed open/ closed.
The rooflight is opened electrically, operated by a rocker switch positioned at the discretion of the client. It includes a ‘one touch’ facility, where the switch is pressed and then released leaving the rooflight to open automatically. The unit can be stopped by pressing close once or can be only part opened by keeping the switch pressed until the desired point is reached. Includes drainage on rails to reduce build up of surface water on framework.
Grey/white frame, clear glass
100% clear opening, polyamide thermal breaks, dual sliding seal mechanism, superior thermally efficient glass
GV Sliding Over Roof Rooflight
Qualicoat approved polyester powder-coated, RAL 7015/ RAL 9010
Standard. RAL 7015 slate grey on the exterior; RAL 9010 white on the interior.
Qualicoat approved polyester powder-coated, RAL, special order
Dual colour; consult manufacturer and insert requirements.
Special stepped kerb required, see manufacturers drawings.
Insert requirement, 150 mm minimum.
Insert requirements, dependent upon rooflight section; consult manufacturer's literature for more information.
Rain sensor overrides
Enduroshield easy clean glass coating
Gives a non-stick surface making the glass easier to clean and keep clean, stay clean for longer and resist staining and discoloration.
Ritec glass coating
Remains disengaged at same time as drive mechanism, allowing for straight forward opening/ closing of rooflight in the event of control failure.
|Standard product features|
Extruded thermally broken aluminium profiles, grade 6063 T6.
24 V batteries, with 240 V mains supply for charging batteries.
Rack and pinion.
Polyester powder coat paint finish:
To the Qualicoat standard.
Combination of EPDM rubber seals and brush strip.
Anti-lifting mechanism to prevent disengagement of drive mechanism via vertical movement of sliding frame.
OR Control Board and magnetic limit switches.
Visual quality of glass:
To the Hadamar standard.
- Double glazed:
- Triple glazed:
Fixed Lantern Rooflight
Fixed Octagonal Pyramid Rooflight
Fixed Pyramid Rooflight
Fixed Ridgeglaze Rooflight
Flushglaze Fixed Circular Rooflight
Flushglaze Fixed Eaves Rooflight
Flushglaze Fixed Rooflight - One Wall Abutment
Flushglaze Fixed Rooflight - Singlepart
Flushglaze Fixed Rooflight - Three Wall Abutment
Flushglaze Fixed Rooflight - Two Wall Abutment