Fire Shutter - Horizontal

Summary:

Bolton Gate Company’s wide range of passive fire resisting products is complemented by the four hour fire resisting horizontal shutter which is capable of closing openings up to 15 m in length and 6 m in width.

On alarm activation, the shutter curtain formed from heavy duty curved profile laths mounted between fabricated guide channels is driven out electrically along the horizontal.

The bespoke shutter is ideally suited to provide fire integrity compartmentation where equipment or materials need to be transferred between floors. Alternatively, it can be used on travelators and escalator openings that are not specifically used as part of the fire exit strategy.

Suited for both fire and non-fire rated applications the shutter is manufactured here, in our Bolton factory, with each shutter assembled, pre-wired and tested prior to despatch to simplify the site commissioning process.

Operation

The flange mounted motor is designed to suit a 400 V nominal, 3ph, 50 Hz supply which is capable of automatic changeover to a third party standby generator / power   supply to ensure continued operation in the event of mains failure.

Emergency operation is facilitated by means of a removable hand crank.

A control panel is provided with integrated open / close / stop push button controls and the facility to receive an alarm signal from the building management system. 

In the event of fire, the shutter is activated by an incoming signal and after a timed delay the curtain will be driven to the closed position.

Curtain

The shutter curtain is constructed from continuously interlocking, pretensioned, 63 mm curved profile galvanized steel laths complete with endlocks.

The laths are connected at each end to a heavy duty drive chain ensuring a smooth horizontal pay-out and return of the curtain.

Bottom Rail

A full width galvanized steel angle is provided at the leading edge of the curtain to provide a complete closure.

Side Guides

Fabricated from mild steel plates designed for fitting to a balustrades or masonry side walls. A section of the side guide top plate is removable to allow maintenance access.

Shutter Box

The shutter enclosure is constructed from suitable mild steel endplates incorporating bearing wheels for roller and gears and includes mounting angles for bolting through to the floor.  The sides are clad with steel sheets to complete the fire resisting assembly.

The shutter curtain is coiled on to the roller barrel which is mounted onto a central shaft. This shaft is retained in bearings and incorporates a patented constant tension spring mechanism to ensure even coiling.

Finish

The Horizontal fire shutter is supplied in a galvanized finish as standard. Where non-galvanized parts are utilised, these are finished with one coat of primer paint.

Maximum sizes:

• 6000 mm wide.
• 15000 mm long.

Weight

Options

• Balustrades for side guide support.
• Curved side guides for closing to the floor.
• Smoke and heat detectors.
• Audio / visual warning.
• Polyester powder coat finish to a single RAL colour.
• Battery back up for use in the event that a protected maintained supply is not available.