RonaFloor HB 100/ 200

Solvent free epoxy floor coating, for use on interior concrete, polymer screeds and granolithic floors. It can be used on exterior concrete but colour fades under UV light. RonaFloor HB200 can be applied to vertical surfaces; the applied thickness must be reduced by approximately 25% to prevent slumping. RonaFloor HB100 must not be used vertically.

Features:

• Bond strength: Exceeds 4 N/mm² before failure of substrate concrete.

• Colour range allows use for floor markings, walkways, traffic aisles etc.

• Cured dry film thickness for two coats: between 0.2 mm for HB100 and 0.4 mm for HB200.

• Good abrasion and chemical resistance.

• Provides smooth gloss finish, unless modified.

• Slip resistance may be introduced by application of kiln-dried aggregate to first coat.

Application:

• Prepare concrete in accordance with instructions.

• Particularly porous floors may require application of at least one coat of RonaFloor Epoxy Primer.

• Drying concrete may require application of RonaFloor Epoxy DPM.

• Apply by roller first coat of RonaFloor HB100 or 200.

• Optionally apply kiln-dried aggregate to wet first coat for slip resistance and remove excess aggregate when dry.

• Apply second coat of RonaFloor HB100 or 200 and allow to cure before trafficking. Note that coverage of second coat on an aggregated surface will be reduced.