NBS Source
Newton 701-HB


As a waterproof, tough, chemical resistant floor coating or as an internal lining for concrete or steel storage tanks containing oils, chemicals, or water. It is particularly suitable for chemical bunds.

Suitable for use in:

  • Food preparation areas;
  • Breweries;
  • Abattoirs;
  • Bottling factories;
  • Manufacturing areas;
  • Industrial units;
  • Warehouses;
  • Aircraft hangers.


A two-component, solvent free epoxy resin based floor coating developed to provide protective and decorative properties to concrete, steel and other substrates. The material is supplied as a two pack system comprising pre-weighed amounts of base and curing agent. After mixing together, an easily applied chemical and abrasion resistant finish is produced.

Consult manufacturer's literature for relevant mixing, surface preparation and application instructions.

Features and benefits:

  • Solvent free, low odour.
  • Provides a fully sealed surface with good chemical resistance.
  • High level of adhesion to concrete and steel.
  • High build.
  • Tough and durable.
  • Easily applied.
  • Hygienic and easily cleaned.
  • Can be applied via brush, short piled roller, or airless spray.
  • If a non-slip finish is required, broadcast an appropriate Silica Sand immediately after the first coat - consult manufacturer for further details.

General information




Component A: Grey; component B: Milky white, Finish: colour (when cured): Grey.



Solvent free epoxy resin


Coverage: 0.25–0.3 kg/m². A 5 kg pack is sufficient to coat 8.3–10 m² of surface with the recommended two coat treatment, providing an overall thickness of 425–500 microns

Uniclass 2015

Pr_35_31_06_38 High-build floor coatingsPrimary


M60/180 Floor coating

Product range


Specification data - High-build floor coatings Enhanced data

Product Reference

Newton 701 HB (LM701)

Specific gravity


Shelf life

12 months.

Pot life at 10°C and Relative Humidity (RH) of 40%

60 minutes.

Application rate - First coat over primer

0.25 kg/m².

Application rate - Further protective coats

0.25 kg/m².

Application method

Brush, roller or squeegee.

Minimum application temperature - substrate

+5 (and rising) °C.

Maximum application temperature - air

+30 °C.


Slight ammonia.

VOC content

Below 100 g/L.

Membrane thickness - First coat over primer

0.15 mm.

Membrane thickness - Further protective coats

0.15 mm.

Impact resistance - Class 2

14 Nm.

Resistance to dilute acid/alkaline


Shore Hardness - D


Slip resistance