BBA Agrément Certificate
A weather-resistant, through-coloured monocouche render that is used for both new build or refurbishment projects.
Suitable for use on:
Through-coloured monocouche render which can achieve a dry dash, scraped or roughcast finish – suitable for most types of brick or blockwork.
Features and benefits:
Not suitable for use on construction board substrate (concrete particle board/render board), use weberend MT - Not suitable for use on insulation board substrate, use webertherm XP.
Available in a range of 24 colours.
M20/160 Proprietary cement gauged render
M20/19 Proprietary cement gauged render
weber CL150 Fungicidal Masonry Wash.
For existing substrates, or where required on new substrates, drench apply CL150 wash and leave for 48 hours, then brush down to remove all moss/ growth.
Helps to provide a mechanical key.
Apply with a hawk and trowel in a tight layer 2–3 mm thick to the substrate. Texture the surface using a well loaded roller. Apply no more than 2–3 m² before texturing. It is important that the final texture achieved should be deep, heavy stipple finish with a minimum textured depth of 5–10 mm. Insufficient key will inhibit the render bond; this is particularly relevant on low suction substrates where capillary absorption is minimal. Leave to cure for 48 hours.
Glass fibre reinforcement
weber standard meshcloth.
To be installed in accordance with manufacturer's recommendations. Balanced, open weave glass fibre meshcloth, coated for alkaline resistance. 1 x 50 m roll.
Weber recommend incorporating weber standard meshcloth into the weberend aid key coat or to the first pass of the weberpral first coat, to areas of typical stress points in the construction.
Accessories/ Other requirements
Render only beads, if required by the system or product, or if specified, shall be of appropriate design, gauge and material - consult manufacturer for details. Structural, temporary or bead fixings shall be of suitable strength and durability. Some available accessories include:
Where window frames incorporating window cills are to be provided by others, then the cill must project sufficiently beyond the outside line of the Saint-Gobain Weber render system to a recommended 40 mm minimum - consult manufacturer for further details.
21 kg/m² at 15mm application dependent.
Curing with a fine spray of clean water may be necessary during rapid drying conditions, In hot climates curing as above is essential for 3 – 5 days after application.
A1 Non combustible.
(Based on less than 1% organic content).
Country of material origin
Country of product manufacture
© 2022 NBS Enterprises Ltd. All rights reserved.