Verified by manufacturer 5 months ago
A polymer-modified binder for use in rapid-set cement screeds allowing early flooring installation.
For indoor and outdoor use.
A special polymer-modified binder for use in rapid-set cement screeds allowing early flooring installation, based on DIN 18 560. Low-chromate to Regulation 1907/2006/EC, Annex XVII.
Features and benefits:
Particle distribution (grading curve) for aggregate (screed sand) shall fall within A8/B8 range under DIN 1045 Part 2, Annex L, Diagram L.1, and shall exhibit an adequate, though not overly high proportion of fine sand; percentage passing a 0.25 mm sieve: approx. 7–10 %.
- Mixing ratio 1:4:
- Mixing ratio 1:5:
Pr_35_31_06_64 Polymer-modified levelling screed mixesPrimary
M10/110 Bonded cement:sand levelling screeds
M10/115 Cement:sand levelling screeds
M10/12 Proprietary polymer modified levelling screeds
M10/130 Proprietary quick drying levelling screeds
M10/140 Proprietary polymer modified levelling screeds
M10/7 Proprietary quick drying levelling screeds
M40/320 Existing concrete/ screeds
Maximum and minimum screed thickness depends on incorporated aggregate. Screed should be at least three times and at most ten times as thick as maximum particle diameter of aggregate. Recommended grading of screed aggregate 0–8 mm; coat thickness approximately 25–80 mm.
2–3 hours (approximately).
Stiffened mortar must not be retempered by addition of water or fresh mortar to restore workability.
Walkable: After 7–8 hours; Ready to receive floor covering: For tiling: after approx. three days; for impervious coverings: after 3–5 days and after achievement of residual moisture content ≤1.8% CM.
Floor heating systems, 25 mm pipe cover.
Suitability for castor chairs
(Castor chair resistance)
Suitable (for castors to DIN 68131).
Country of material origin
Country of product manufacture
A1-A3 (production stage) as defined in BS EN 15804
4.88 kg CO₂ eq/kg
NBS BIM object standard
This BIM object has been authored to meet the requirements of the NBS BIM object standard.
Find out more about the NBS BIM object standard.