Endex Copper End Feed Capillary Fittings

Endex is a range of end feed capillary fittings, manufactured to BS EN 1254-1 from copper, gunmetal and dezincification resistant alloy (DZR), available in sizes from 6–54 mm

Suitable for use on above ground hot and cold domestic/potable water services in small bore and mini bore central heating systems and in low-pressure steam heating and pressurised unvented heating systems

Also suitable for sanitation services and compressed air lines, gas distribution systems for natural and manufactured gases, with fuel oils (hard solder only) and Kerosene, and on engineering pipeline services that convey liquids, oils, air and gases at temperatures up to 110°C

Available degreased and individually bagged for use on medical gas lines

WRAS/REG4 approved

The range includes:

• N1 Straight Coupling
• N1M Straight Coupling (Imperial x Metric)
• N1R Reducing Coupling
• N1S Straight Clip Coupling
• N2 Straight Female Connector
• N3 Straight Male Connector
• N6 Reducer
• N7 Female Adaptor (Male Copper)
• N8 Male Adaptor (Male Copper)
• N9 Adaptor (Imperial Female x Metric Male)
• N11 Union Coupling
• N12 Elbow 90deg
• N12R Reducing Elbow 90deg
• N12S Street Elbow 90deg
• N13 Male Elbow 90deg
• N14 Female Elbow
• N15 Backplate Elbow
• N18 Slow Bend 90deg
• N18S Slow Street Bend 90deg
• N21 Obtuse Elbow 45deg
• N21S Obtuse Street Elbow 45deg
• N22 Partial Crossover (Female x Male)
• N23 Full Crossover
• N24 Equal Tee
• N25 Reduced Branch Tee
• N26 One End Reduced Tee
• N27 One End and Branch Reduced Tee
• N28 Both Ends Reduced
• N29 Female BSP End Tee
• N30 Female BSP Branch Tee
• N30R Female BSP Branch Reduced Tee
• N50 Cross
• N61 Stop End
• N61AV Air Release Stop End
• N62 Straight Tap Connector
• N63 Bent Tap Connector (Female End)
• N64 Bent Tap Connector (Male End)
• N65 Bent Male Union Connector
• N68 Straight Union Adaptor
• N68FF Flat Faced Union Adaptor
• N68M Straight Gas Meter Union
• N69 Straight Male Union Connector

All Endex general range fittings are listed and comply with the requirements of The Water Supply (Water Fittings) Regulations/Byelaws (Scotland)

BS EN 1254 Part 1 Specification for copper and copper alloy fittings with capillary ends for soldering and brazing for use with copper tubes

BS EN ISO 228 (formerly BS 2779/ISO 228/1) Specification for tubes and fittings where pressure tight joints are not made on the threads (metric dimensions)

BS 7786 Specification for PTFE tape for water and general applications

BS EN 751-3 (formerly BS 6974) Specification for PTFE tape for gas applications

Our fittings come with a standard 25-year guarantee. If installed in conjunction with Yorkshire copper tube, manufactured to BS EN 1057 then the guarantee is extended to 30 years