Centrecoat MMA Flex - MMA Bay/ Walkway Marking Paint

For tarmac, asphalt and concrete type surfaces, e.g. parking bays, block paving, ramps, cycle paths, driveways, steps, etc.

Asphalt and tarmac surfaces must be clean, dry and free from contaminants. New asphalt and tarmac must be allowed to ‘weather’ to ensure any excess oils are released. Mechanical preparation is not normally necessary, however vacuum shot blasting can be employed to clean the surface should this be required, and will provide a better mechanical ‘key’ in heavy duty environments.

No primer required for asphalt and tarmac surfaces. Prime using Centrecoat MMA Multi-Use Primer on concrete and block paving. (please refer to Centrecoat MMA Multi-Use Primer data sheet). Centrecoat MMA Flex is supplied as a two pack material consisting of the RESIN component, and the CATALYST component. Incorporate the CATALYST component under mechanical stirring and mix for 1–2 minutes.

Apply Centrecoat MMA Flex using short nap perlon or smooth lambswool rollers at a nominal rate of 0.3–0.6 kg per m². Should a slip resistant finish be required then broadcast an appropriate aggregate onto the first coat within 10 minutes of application. Following a minimum of 1 hour, sweep off excess aggregate, and apply a second coat of Centrecoat MMA Flex.

Clean equipment with Centrecoat MMA Tool Cleaner immediately after use.