BAL Waterproof 1C - Tanking System
Verified by manufacturer 6 months ago
Ready to use polymer system.
Application
Use for:
Providing complete waterproofing protection of substrates prior to fixing wall and floor tiles. Suitable for use in internal domestic and commercial situations.
All corner/edges must be reinforced with BAL SCRIM TAPE is required:
- Where movement may occur such as around drainage channels, junctions between floor and wall, preventing water penetration through suspended floors.
- For showers/ wet rooms/ kitchens/ laundry/utility room, and around drainage/ upstands.
Suitable surfaces:
- Concrete; cement: sand screeds and rendering.
- BAL QUICKSET CEMENT: sand screeds and rendering.
- BAL Board.
- Plaster (finish coat only) – Internal only.
- Plasterboard (If required) - Internal only.
- Glazed/Unglazed ceramic tiles, quarry tiles, terrazzo and natural stone.
- Fibre reinforced cement boards and lightweight tile backer boards.
- Undertile electrical heating systems.
- Onto BAL RAPID-MAT.
- Overlaid timber floors (min. 15 mm).
See manufacturer's literature for further information.
Description
Fast drying one coat ready to use tanking system for internal wet areas.
Features and benefits:
- Brush, roller or trowel applied.
- No mixing required and can be used again.
- Can be used without priming.
- Ability for one coat application.
- Tile after two hours.
- Static Cracks and board joints bridged up to 3 mm without tape or matting on the floor.
- Total waterproofing protection for internal locations.
Not suitable for external use, total immersion, barrier to prevent water ingress from background/base (e.g. DPM).
General information
Color | Grey |
Finish | Other |
Material | Polymer |
Shape | Formless |
Warranty description | 25 year |
Uniclass | |
CAWS | E60/130 Precast slab J30/130 Cold-applied damp-proofing J30/110 Cold-applied tanking |
Specification data - Liquid tanking resins
Composition | Polymer.Guidance for specification option: Ready to use polymer system. |
Pack size | 5 L. |
Drying time | 2 hours at 20°C. |
Coverage | Manufacturer guidance
|
Bed height | 0.8 mm (walls), 1.6 mm (floors). |
Temperature resistance | -15°C to 70°C. |