New Ensign Rodding Branch
The new Ensign rodding branch that combines 8 components into one fitting. Traditionally, when the horizontal pipework changes direction, installers would need to add a short length of pipe, and end cap to allow access for rodding, a support bracket and even, on certain installations, a set of pressure grip collars to accommodate thrust pressures at the end of a pipe run. This entire process can involve the use of up to eight separate components and would take a significant amount of time, even for experienced installers.
The new 100mm diameter branches are available in 45° angles for horizontal directional change and 90° angles for use where the vertical pipe stack connects to the horizontal pipe run.