Starter Strip PLUS

Helps Protect Against Nature's Elements

Starter Strip Plus Shingle is packaged two pieces per shingle, and perforated down the center for easy separation.

• Provides a machine-cut straight edge at the eave and along the rake for a clean look
• Easy for one person to position on the roof
• For use with any shingle that has an exposure up to 6 inches
• Continuous sealant provides exceptional bonding strength, ensuring an effective seal between the starter and the first course of shingles
• Convenient as one bundle provides one square of material (105 linear feet of actual coverage)

Part of the Owens Corning® Total Protection Roofing System®^.

Download Brochure

Specifications & Literature

Data SheetsStarter Strip Plus Data Sheet

Technical Information

Shingle Size: 15-1/2 " x 39-3/8" (394 mm x 1000 mm)

Piece size: 7-3/4 " x 39-3/8" (197 mm x 1000 mm)

Shingles per Bundle: 16

Pieces per Bundle: 32 (7-3/4 " x 39-3/8" [197 mm x 1000 mm])

Lineal Feet per Bundle: Approximately 105 (32.004 m)

1. Includes core weight

2. All values are approximate.

3. Limited to single layer applications above 650°F (343°C), but not greater than 6" (152mm) thickness.

4. With heat up schedule.

5. The surface burning characteristics of these products have been determined in accordance with UL 723, ASTM E84 or CAN/ULC-S102. Values are reported to the nearest 5 rating.

6. Preproduction qualification testing

7. It is critical to have the right amount of intake ventilation and to adequately seal the attic floor to prevent pulling air from conditioned space.

8. For each Gable Mount fan, Owens Corning Roofing requires 890 square inches of intake. See instructions for details.

9. For each Roof Mount fan, Owens Corning Roofing requires 600 square inches of intake. See instructions for details.

10. The surface burning characteristics of these products have been determined in accordance with UL 723, ASTM E84 or CAN/ULC-S102. This standard should be used to measure and describe the properties of materials, products or assemblies in response to heat and flame under controlled laboratory conditions and should not be used to describe or appraise the fire hazard or fire risk of materials, products or assemblies under actual fire conditions. However, results of this test may be used as elements of a fire risk assessment which takes into account all of the factors which are pertinent to an assessment of the fire hazard of a particular end use. Values are reported to the nearest 5 rating.

11. Preproduction qualification testing complete and on file. Chemical analysis of each production lot required for total conformance.

^ Excludes non-Owens Corning™ Roofing Products such as flashing, fasteners and wood decking.