Rada V12 Exposed Shower Valve

Connections:

• Inlets: 15 mm compression.

• Outlet: ½” BSP Flat Face/ 15 mm compression.

• Standard connections are: hot- left, cold- right, outlet- bottom or top.

Operation:

The Rada V12 is operated via a single sequential control which when rotated initially opens the valve, then increases temperature from cold to a pre-set maximum.

Temperature Range:

• Temperature range from cold to preset maximum.

• The maximum temperature that can be selected is factory set at approximately 43°C, but this can be reset on site if required (by an authorised person).

• Thermostatic control ± 1°C within the range 35–45°C (assuming supplies of 15–65°C hot at nominally equal pressures).

Note: In the event of loss of either supply, the valve will automatically shut off. Minimum temperature differential of blend to either supply 10°C.

Supply:

• Cold water temperature range 5–25°C.

• Hot water temperature range (recommended) 60–65°C.

• Maximum hot water temperature 85°C.

Note: For reasons of general safety, hot water storage temperatures should be maintained at between 60–65°C where serving ablutionary applications. The mixing valve can accept temporary excursions above 85°C without damage, however operation at such elevated temperatures is not recommended.

Pressure:

Dynamic supply pressure (Running):

• Minimum: 0.1 Bar.

• Maximum: 5 Bar.

• Maximum Static: 10 Bar.

• For optimum operation the inlet pressures should be nominally equal.

• Maximum Pressure loss Ratio should not exceed 10:1 in favour of either supply during flow.

Materials:

• Body and Elbows: Chrome Plated Polished Brass.

• Lever: Chrome Plated Zinc Die Casting.