Nu-Flame Fire Protection Coating

Nu-Flame High-Build Metal Primer:

A high-build quick drying corrosion resistant metal primer, suitable for shop or site painting and compatible Nu-Flame and most other intumescent paint systems, epoxy and conventional systems.

• Volume Solids: 50%.

• Coverage Rate: 6 m²/litre.

• Dry Film Thickness: 75 microns.

• Drying time: Touch dry 30 minutes, Hard dry 1 hour. Overcoating 2 hours.

• Minimum temperature 6°C. Maximum Relative Humidity 80%. Minimum steel temperature 3°C above Dew Point.

Nu-Flame S Base Coat:

A thin film, solvent-based decorative intumescent paint system providing fire resistance of up to 2 hours with a two coat application

• Colour: White.

• Volume Solids: 65-75%.

• Coverage Rate: Depending on fire rating required, contact Hydron Technical department for details.

• Drying time: Brush/Roller - Touch dry 2 hours. Re-coat 4 hours. Spray - Touch dry 4 hours. Re-coat 10 hours.

• Allow to dry for minimum 48 hours before overcoating with Nu-Flame Steel Top Coat.

• Minimum temperature 6°C. Maximum Relative Humidity 80%. Minimum steel temperature 3°C above Dew Point.

• Maximum Thickness per coat: Brush – 600 microns DFT.

• Maximum Thickness per coat: Spray – 1800 microns DFT.

Nu-Flame W Base Coat:

A thin film, water-based decorative intumescent paint system providing fire resistance of up to 2 hours with a two coat application.

• Colour: White.

• Volume Solids: 65-75%.

• Coverage Rate: Depending on fire rating required, contact Hydron Technical department for details.

• Drying time: Brush/Roller - Touch dry 2 hours. Re-coat 4 hours. Spray - Touch dry 4 hours. Re-coat 10 hours.

• Allow to dry for minimum 48 hours before overcoating with Nu-Flame Steel Top Coat.

• Minimum temperature 6°C. Maximum Relative Humidity 80%. Minimum steel temperature 3°C above Dew Point.

• Maximum Thickness per coat: Brush – 600 microns DFT.

• Maximum Thickness per coat: Spray – 1800 microns DFT.

Nu-Flame Steel Top Coat:

A hard, single coat, high-build, flame retardant anti-corrosion coating, resistant to physical damage, chemicals and weathering. In severe exposure or environmental locations apply a coat of semi-gloss followed by a coat of full gloss top coat. The product is based on a high durability resin, antimony oxide flame retardant agents, high opacity and corrosion resistant pigments.

• Volume Solids: 45-50%.

• Coverage Rate: 7 m²/litre.

• Recommended film thickness: 70 microns dry / 150 microns wet.

• Minimum temperature 6°C. Maximum Relative Humidity 80%. Minimum steel temperature 3°C above Dew Point.

Fire resistance to BS 476-21:

Insert requirements up to 120 minutes.

Nu-Flame High-Build Metal Primer:

• Available in Grey, White and Red.

• Application: Brush/ Roller/ Airless Spray – spray using 0.013-0.017" tip.

Nu-Flame S Base Coat

• Application: Brush/ Roller/ Airless Spray.

Nu-Flame W Base Coat:

• Application: Brush/ Roller/ Airless Spray.

Nu-Flame Steel Top Coat:

• Colour: Gloss and Semi-Gloss in BS 4800 and RAL shades.

• Application: Brush/ Roller/ Airless Spray.