A two component, high solids, low VOC, epoxy zinc phosphate/ micaceous iron oxide primer.
As a primer for steelwork intended for use in a wide range of environmental conditions, including offshore, chemical and petrochemical plants, industrial buildings, pulp and paper mills, power plants and bridges. Suitable for overcoating within seven hours in most climatic conditions. Provides quick cure even at low temperatures often encountered in maintenance painting. It can also be used as a primer for substrates other than blasted steel, e.g. stainless steel, alloys etc. Not intended for use as a primer for steelwork which may be subjected to continuous immersion conditions.
Intercure 200HS will normally be applied to suitably prepared steel, e.g. blast cleaned. However, if necessary, application over prefabrication blast primers can be performed. Consult International Protective Coatings for further details.
Intercure 200HS is a zinc phosphate epoxy primer/intermediate.
Features and benefits:
G10/630 Galvanizing plus site-applied
G10/635 Thermally sprayed zinc coating plus site-applied
G10/638 Shop priming
G10/640 Shop painting
G10/643 Protective painting
G10/65 Shop priming for
G10/650 Site painting
G10/660 Shop plus site painting
G12/20 Shop priming
G12/330 Proprietary metal members
G12/650 Shop priming
Suitable for industrial environment.
Intended for use in a wide range of environmental conditions including offshore, chemical and petrochemical plants, industrial buildings, pulp and paper mills, power plants and bridges.
Application of powder coating.
Wet film thickness (minimum)
Dry film thickness