NBS Source
List your products
Description

Intec injection hose systems are a sealing method for horizontal and vertical construction joints. They provide a secure, simple and rapid method for sealing joints. Intec injection hose systems are suited for sealing applications using the injection hose only and for supplementary sealing only when leaks are discovered. The system comprises injection hoses, injection material and the required accessories.

Intec Premium – recommended for multiple injection applications:

Intec Premium is a well-proven injection hose system for joint sealing using PUR, EP and acrylic resins. The design features of the Intec Premium mean that the injection hose can be cleaned by a flushing process under pressure. The system is therefore suitable for multiple injections using both PU and acrylic resins. An additional benefit is the possibility to inject over longer lengths than most other injection hose systems. Intec Premium has been independently tested and certified for multiple injection applications with PU resins.

Intec Standard – recommended for single injection applications:

Intec Standard is a well-proven injection hose system for joint sealing using PUR, EP and acrylic resins. Intec Standard has been independently tested and certified for single injection applications.

Intec Cem – recommended for multiple injection applications:

Intec Cem injection hose is mainly used for the injection of cement paste or cement suspension, but can also be injected using acrylic and PU resins. Intec Cem is mainly used to seal the voids produced during concreting in underpinning and tunnelling applications. Voids are non-pressure positive injected using cement paste or cement suspension. Additional injections are possible after cleaning of the hose using a vacuum process. Intec Cem has been independently tested and certified for multiple injection applications.

General information
Specification data
Product Reference

Intec Cem

Intec Premium

Intec Standard

Injection material

Intectin Acrylic Resin

Intectin Blitz

PUR resin, including accelerator.

Intectin EP

Intectin Plus

Accessories

Consult manufacturer's literature and insert requirements.

Product Options

Injection material:

  • Intectin Acrylic Resin: Low-viscosity, two-component acrylic injection resin, approved for drinking water applications to KTW recommendations. Water-soluble before hardening – swells on contact with water after hardening. Particularly suitable for reusable injection hoses. Working temperature down to 0°C. Anti-corrosive due to active corrosion protection.
  • Intectin Blitz: Foams in contact with water and stops the water flow, accelerator content: approximately 10%.
  • Intectin EP: Two-component contact epoxy resin for force-fit crack sealing or also for force-fit/ filling injection hose, suitable for dry and damp surfaces.
  • Intectin Plus: PUR resin according to DIN-EN 1504-5 with CE mark and drinking water suitability test according to KTW recommendations. Suitable for hose pressing and crack injection. The resin has low viscosity and hardens elastically with extended dropping time (corresponding to 100 minutes).