Hockey fencing systems.
Zaun’s Hockey 200 has been developed specifically with hockey in mind. The system overcomes the problems with traditional wooden board fencing, which is expensive, needs replacing and creates a lot of noise during play. It uses twin wire 8 mm wires in a close 25 x 50 mm mesh pattern to clad the lowest 210 mm of the fence.
This results in an extremely robust section of fence that is able to withstand the cannonball-like impacts that occur during a game of hockey. Measured under the same conditions the noise from ball impact on traditional hockey boards was 97 dB, while Zaun Hockey 200 fencing produced a noise of only 68 dB.
Fixings every 200 mm and synthetic rubber inserts at each fixing virtually eliminate rattle during play. A clamp bar covering the panel ends ensures a safe playing surface with no sharp edges.
Features and benefits:
Galvanized and polyester powder coated
0.43–6.0 m, insert requirements.
Single leaf, 1.2 m wide, or width to suit, consult manufacturer and insert requirements.
Double leaf, 3.0 m wide, or width to suit, consult manufacturer and insert requirements.
|Standard product features|
Galvanized and polyester powder coated.
Hockey mesh comprising 200 mm of 25 x 50 mm mesh and 200 x 50 mm Duo8 mesh above with single 6 mm vertical wires 50 mm centres and dual 8 mm horizontal wires at 200 mm centres.
Rectangular hollow section (RHS) sports posts - sizes dependent on height, spaced at 2525 mm centres, consult manufacturer.
Post to panel fixing:
Panels fixed to posts with full height 40 x 5 mm clamp bar with bolt fixings at 200 mm centres with EPDM inserts. The full height clamp bars create a flush safe finish with the mesh ends behind the clamp bar.
Framed in 50 x 50 mm RHS, with Zaun Hockey 200 mesh welded inside the frame, with slide latch. Gate supplied with rubber bump stop and two suitable gate posts. Vehicular access also supplied with drop bolts.