FR-4H

Curtain slat:

• Single skin 76 mm curved steel.

• Standard galvanized finish.

• Visible surface: 76 mm.

• Profile height: 86.6 mm.

• Weight: 10–16 kg/m².

Housing:

• Manufactured from 0.9 mm galvanized steel sheet.

• End caps fabricated from 5 mm steel, or thicker.

Shutter height:

• Up to 2500 mm: Box size 305 mm.

• Up to 4000 mm: Box size 355 mm.

• Up to 5500 mm: Box size 400 mm.

Guide channels/ bottom slat:

• Galvanized steel sections with strengthened T-shape bottom bar.

• Guide channel depth with vary dependent on application from 65–100 mm (utilizing windlocks on the slats).

• Standard galvanized finish, other colours on request.

• Guide channels are bolted into angle or box section, depending on the application.

Manufacturing standards:

• Fully CE marked.

• Mechanical aspects: BS EN 12604, safety in use of power assisted doors.

• Side guide protection: BS EN 12604-4.5.1 and BS EN 12453-5.1.1.3.

• Protection: Against crushing, shearing or drawing in.

• Electrical safety: Depending on use.

• Watertightness: To BS EN 12489.

• Resistance to windload: To BS EN 12444.

• Thermal resistance: To BS EN 12428.

• Air permeability: To BS EN 12427.

• Opto safety edge self-monitoring: To BS EN 12453-5.1.1.5.

• Anti-fall back device: To BS EN 12453-5.1.1.5.

• Installation instructions: To BS EN 12635-4.1.1.1.

• Durability of mechanical performance: To BS EN 12635-4.1.1.1.

• Fire test: BS EN 476-22.

Control:

• F-Mate: Will wire into the alarm and simply send the shutter up or down when alarm is triggered using a normally open, volt free signal.

• SF-01NRG: Will wire into the fire alarm and either go up or down when the alarm is triggered. There are also lights and a 90 dB warning alarm signalling the imminent descent of the shutter. This control panel can be set on a delay.

• FCP A-Spec: Will wire into the fire alarm and either go up or down when the alarm is triggered. There are also lights and a warning alarm signalling the imminent descent of the shutter. This control panel can be set on a delay. Comes with an emergency mushroom push button which can be pressed to temporarily send the shutter back up. Shutter will come back down after a delay.

Operation:

• Electric – single-phase tubular motor or inline chain driven motor (dependent on curtain weight) with push button control. Inline motors in either single phase or three phase supply. The fire shutter is usually connected to a fire control panel and integrated within the building alarm system, so that the shutter descends under control of the motor in the event of a fire.

• Manual override facility is available with the UKRS FS range.

• Optional battery back-up will supply at least one operation of the door if electricity supply fails.

• CE compliant to all relevant European directives and regulations.