NBS Source
I'm a manufacturer
Compare variants

Flowpatch Range - Pourable repair mortar

Verified by manufacturer 3 months ago

Flowpatch®

Watco UK Ltd Variant:

A range of pourable concrete repair mortars for filling holes in concrete or asphalt floors inside or out.

Jump to:
+44 (0)1483 418418 Website

Application

Mixing

Mix the water at the following ratio: 1kg of powder to 100ml of water.

Due to the short working life of the mixed product, we recommend you carry out the mixing near to the repair and not near to the water source. Put the water into the empty bucket and gradually add the powder stirring constantly to achieve a pourable slurry.


Application

When a smooth consistency is achieved, simply pour it in to the hole.


Working time

Approximately 5 to 10 minutes at 20°C, so do not mix at one time more than you can use within a few minutes.

Description

Flowpatch®:

An easy to mix pourable material for quick repairs to level concrete, inside or outside. Very strong and hardening quickly, it will accept heavy traffic including forklifts just two hours after application.

  • Can be applied from 10mm to 100mm
  • Ideal for filling deep holes before screeding.


Flowpatch® sub zero:

A pre-mixed magnesium phosphate cement blended with specially selected aggregates, that will cure rapidly, even at -20°C and accept traffic after just two hours. Ideal for repairing holes or levelling damaged concrete floors in freezer and chiller rooms. Also suitable for general external repairs in cold conditions.

  • Can be applied from 10mm to 100mm
  • Ideal for filling deep holes before screeding.


Ideal for

  • Cold stores.
  • Securing railings.
  • Poles and posts.
  • Roads and manhole frames etc.


Flowpatch® Deep Fill:

An easy to mix pourable material for quick repairs to deep holes in level concrete, inside or outside. Very strong and hardens quickly, it will accept heavy traffic including forklifts only two hours after application.

  • For holes between 10-200mm


Flowpatch Asphalt Repair:

For decades we’ve been recommending our bestselling Flowpatch® pourable repair mortar for fast, pourable and strong repairs to concrete. Now, we’ve reformulated this winning formula so you can use it to repair asphalt and tarmac surfaces too.

Traditionally, repairs would involve cutting out around the damaged asphalt and refilling with a similar material. With Watco Flowpatch Asphalt Repair, just pour the mixture straight over the top of the surface erosion and used to fill holes up to 100mm deep in just one layer.

Recommended areas of use

  • Car parks
  • Loading areas
  • Drives
  • Paths
  • Internal asphalt floors



Features and benefits:

  • Just add water, mix and pour.
  • Can be applied to damp (not wet) concrete.
  • Sets at low temperatures (down to 5°C).
  • Can be applied at any depth between 10–200mm.
  • Fibre-reinforced.
  • Magnesium-based formula generates heat when mixed with water, allowing the product to be used as low as -20°C (Sub-Zero version only).
  • Starts to hardens in 10 minutes, fully hard in five hours when suitably insulated (at -10°C) and can be applied at 50mm thick at -20°C (Sub-Zero version only).

General information

Specification data - Concrete repair mortars

Mortar type

Cement based.

Colour

Grey.

Tile red.

Buff.

Green.

Blue.

Coverage

0.5 m².

Guidance for specification option:

At 25 mm thick.

Unit weight

25 kg.

Literature

Data Sheet: Flowpatch Range

Data Sheet: Flowpatch Range

Case studies

Kenwood Warehouse - Concrete floor repairs, for heavy traffic areas

Kenwood Warehouse - Concrete floor repairs, for heavy traffic areas