Net2 Plus 12V 2A PSU, Plastic Cabinet - Single Door Access Control Unit

There is a label on the Net2 plus control unit that clearly shows colour coded connections for reader, power supply etc. The unit has a voltage free relay and so can switch any lock or electrical device. Exit buttons, door contacts, tamper switches and alarm devices may be connected.

Control units communicate to the PC via the standard TCP/IP protocol of a LAN. The Net2 plus control unit should be given a fixed/static IP address. All configuration of the unit is done using the Net2 Configuration Utility.

There are diagnostic LEDs mounted close to their relevant terminals to assist with trouble free installation. End of line resistors can be switched into the circuit as required. External terminating resistors are not required.

Operation – Any changes made at the PC are immediately communicated and stored at the control unit. When a user presents their token to the reader, the control unit identifies them and permits or denies access as appropriate.

Net2 Plus is a single door access control unit. It has on-board TCP/IP to allow direct connection to a computer network, this can save time, money and result in a better, more resilient system.

Features and benefits:

• Can also be connected together using a dedicated RS485 network. This reduces the number of TCP/IP network points required for larger systems.
• Hardware features include the following: Volt free control relay x 2, Input for PSU fail, Input for tamper, Alarm output, Dedicated intruder alarm input.
• The 12 V, 2 A Power supply unit is available in either a plastic or metal cabinet.
• The cabinet can house both the 12 V, 2 A PSU and a Net2 and the option to accommodate a 12 V /7 Ah back-up battery if desired.
• A tamper switch is also installed which registers an alarm if the lid is opened when connected to an ACU.
• Single door networkable access control unit.
• Plug into a TCP/IP network using a RJ45 plug.
• Features a built in TCP/IP converter.
• Different control units can be mixed on a site.
• FLASH memory allows easy upgrades.
• Use Paxton or third-party readers.

The Net2 plus control unit connects to the central administration PC using an RJ45 plug into a standard TCP/IP Ethernet network. This greatly increases the flexibility of installation options on sites that have LAN/WAN networks. The Net2 plus control unit also has a RS485 connection. This means it can be connected to other Net2 plus control units using a dedicated CAT5 cable.

One Net2 plus control unit can be the network interface to the LAN and also run a wired RS485 daisy chain of other Net2 plus units, removing the need for an independent TCP/IP to RS485 converter. Net2 plus is also available with a Power over Ethernet (PoE) power supply. PoE is a technology that allows both power and data to be passed along Ethernet cabling. Net2 plus with PoE simply plugs straight into the existing LAN using a standard RJ45 plug (providing it is powered by either a compatible PoE switch or a PoE injector).

• Net2 Plus is supplied as a PCB only or in a cabinet with or without a power supply. Both metal and plastic cabinets are available, with a 2 A or PoE+ power supply. Both metal and plastic cabinets are available, with a 2 A (battery backup recommended) or PoE+ (UPS recommended) power supply.